Onderzoeksoutput

Welkom op het expertplatform!

Dit platform verschaft informatie en kennis omtrent de WL expertisedomeinen 'hydraulica en sediment', 'havens en waterwegen', 'waterbouwkundige constructies', 'waterbeheer' en 'kustbescherming' - gaande van WL medewerkers met hun expertise, het curriculum van deze instelling, tot publicaties, projecten, data (op termijn) en evenementen waarin het WL betrokken is.

Het WL onderschrijft het belang van "open access" voor de ontsluiting van haar onderzoeksresultaten. Lees er meer over in ons openaccessbeleid.

log in

• 
  People
• 
  Curriculum
• 
  Projects
• 
  Data sets
• 
  Publications
• 
  Events

[ meld een fout in dit record ]

mandje (1): toevoegen | toon

---

one publication added to basket [242491]

Pressure measurement on the surface of a rigid cylindrical body during slamming wave impact Van Nuffel, D.; Vepa, S.; De Baere, I.; Degrieck, J.; De Rouck, J.; Van Paepegem, W. (2011). Pressure measurement on the surface of a rigid cylindrical body during slamming wave impact, in: OMAE2011: Proceedings of the ASME 30th international conference on ocean, offshore and arctic engineering, Vol 2: structures, safety and reliability. pp. 303-312. http://dx.doi.org/10.1115/OMAE2011-49390 In: (2011). OMAE2011: Proceedings of the ASME 30th international conference on ocean, offshore and arctic engineering, Vol 2: structures, safety and reliability. American Society of Mechanical Engineers (ASME): New York. ISBN 9780791844342.

---

Beschikbaar in	Auteurs
VLIZ [ aanvragen ]
Documenttype: Congresbijdrage

---

Auteurs		Top
Van Nuffel, D. Vepa, S. De Baere, I.	Degrieck, J. De Rouck, J. Van Paepegem, W.

---

Abstract

Among all kinds of loads that floating and fixed marine constructions experience, water wave slamming can be considered as one of the most critical. To prevent naval constructions from failing due to slamming impact, slamming loads should be arefully investigated. Besides analytical and numerical calculations, experimental data is of crucial importance. Slamming loads can be measured by performing pressure measurements on the surface of the object during impact. Previous publications showed that precise and correct measurements are very difficult to perform, especially for slamming events with small deadrise angles. Large scatter mostly characterizes these measurements. This research focuses on improving the accuracy and reproducibility of the pressure recordings. Therefore, slamming drop tests are performed on a rigid cylindrical body. Most attention is paid to the bottom of the cylinder where the deadrise angle is 0°.

---

Alle informatie in het Integrated Marine Information System (IMIS) valt onder het VLIZ Privacy beleid

Top | Auteurs

IMIS is ontwikkeld en wordt gehost door het VLIZ.