Skip to main content
Publications | Persons | Institutes | Projects
[ report an error in this record ]basket (0): add | show Print this page

Atmospheric particulate element concentrations and deposition rates in French Polynesia
Rojas, C.M.; Injuk, J.; Van Grieken, R.E.; Maenhaut, W. (2000). Atmospheric particulate element concentrations and deposition rates in French Polynesia. J. Rech. Océanogr. 25(3-4): 74-86
In: Journal de Recherche Océanographique. Union des Océanographes de France: Paris. ISSN 0397-5347, more
Peer reviewed article  

Available in  Authors 

Keywords
    Analysis > Mathematical analysis > Statistical analysis > Variance analysis > Multivariate analysis
    Chemical elements > Metals > Heavy metals
    Colloids > Aerosols
    Environments > Sedimentary environments
    ISE, French Polynesia [Marine Regions]
    Marine/Coastal
Author keywords
    Aerosol, PIXE, atmospheric deposition, multivariate analysis, deposition modeling

Authors  Top 
  • Rojas, C.M.
  • Injuk, J.
  • Van Grieken, R.E., more
  • Maenhaut, W., more

Abstract
    Over a period of eight months, a total of 26 atmospheric particulate matter samples were collected at the location of Tahiti and in other areas of French Polynesia, using a specially equipped sailboat. A 6-stage cascade impact or was used to separate aerosols in the following size classes: > 4,2-4, 1-2,0.5-1,0.25-0.5 and < 0.25 µm equivalent aerodynamic diameter. The resulting set of 156 size segregated aerosol samples was analyzed by particle-induced X-ray emission for 16 elements. This study deals with the concentrations of Na, Mg, Al, Si, S, Cl, K, Ca, Ti, Mn, Fe, Cu, Zn, Br, Sr and Pb. Enrichment factor calculations reveal that Na, Mg, S, A, K, Ca and Sr were little fractionated with respect to bulk sea water, whereas Al, Si, Ti, Mn and Fe presented no enrichment relative to the earth's crust. The anomalously enriched elements were Cu, Zn, Br and Pb. The multivariate technique factor analysis was used to identify the various aerosol sources. Dry and wet deposition modeling enabled us to estimate the atmospheric dry and wet transfer to the sea. Dry deposition velocities ranged from 0.04 to 0.2 cm S-1, while the scavenging rates were of the order of 2-3 x10-6 S-1. The resulting deposition rates are within the range given in the literature, with a good agreement for the deposition of Mn, Cu and Zn. It was found that dry deposition dominates over wet deposition for the sea derived elements, while for the crustal elements, the situation was the opposite. The estimated annual atmospheric deposition of Cu is equal to that of other geochemical cycles such as marine sedimentation and vertical mixing, whereas the deposition rates of mineral aerosol and Pb are much higher than those reported previously, indicating direct influence of local emissions from Tahiti.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors