Skip to main content
Publications | Persons | Institutes | Projects
[ report an error in this record ]basket (0): add | show Print this page

Wave run-up on the Zeebrugge rubble mound breakwater: full-scale measurement results
De Rouck, J.; Van de Walle, B.; Troch, P.; van der Meer, J.W.; Van Damme, L.; Medina, J.R.; Willems, M.; Frigaard, P. (2007). Wave run-up on the Zeebrugge rubble mound breakwater: full-scale measurement results. J. Coast. Res. 23(3): 577-583. dx.doi.org/10.2112/04-0157.1
In: Journal of Coastal Research. Coastal Education and Research Foundation: Fort Lauderdale. ISSN 0749-0208; e-ISSN 1551-5036, more
Peer reviewed article  

Available in  Authors 

Keywords
    Cubes
    Gauges
    Prototypes
    Marine/Coastal
Author keywords
    prototype; grooved cubes; gauge

Authors  Top 
  • De Rouck, J., more
  • Van de Walle, B., more
  • Troch, P., more
  • van der Meer, J.W.
  • Van Damme, L., more
  • Medina, J.R.
  • Willems, M., more
  • Frigaard, P.

Abstract
    Full-scale wave run-up measurements have been carried out on the Zeebrugge rubble mound breakwater in the frame of the EU-funded OPTICREST project. Wave run-up has been measured by a run-up gauge and by a so-called spi-derweb system. The dimensionless wave run-up value Ru2%/Hm0 measured in Zeebrugge equals 1.77 for Iribarren number om = 3.63. An (apparent) influence of the water level on wave run-up has been observed. The porosity of the armor layer has a significant influence on wave run-up and may explain the dependency of wave run-up on the water level observed in Zeebrugge. Full-scale measurement results have been compared to literature data. The full-scale wave run-up data are in good agreement with the existing results of wave run-up tests with rip-rap slopes but are clearly higher than other wave run-up data resulting from tests with rubble mound breakwaters.

All data in the Integrated Marine Information System (IMIS) is subject to the VLIZ privacy policy Top | Authors